This downlight has been manufactured to fit the 92mm hole which exists in most Australian homes.Remove the old halogen and there is no need to recut the hole in probably 98% of cases.These downlights produce more light than halogens – about 1 1/2 times and use the same 60 degree beam angle.

Above is a photo of a kitchen bench lit by a halogen on the left and this LED downlight (but in cool white), on the right (end of benchtop). You can actually see what you are doing when preparing meals, reading mail etc. It is an amazing light which people have bought for their office, dining room, places to read by, etc. It makes such a difference to ’seeing’.

It is advisable to purchase an accredited driver to achieve the full life span of your light at maximum brightness.It is also important for insurance purposes to have SAA approval for the driver.Our drivers have SAA approval.

This LED light uses 18W, while halogen lights use 50+W. You should be able to use less of these downlights than halogens and have a better colour rendition and very little heat.

PRODUCT FEATURES:
No UV or IR Radiation;
Low Power Consumption;
Long lived performance

Even Lighting, Non-halation, High intensity;
Unique Radiation Design;
Constant current circuit;
Safe and easy to assemble;
With Power Supply Adapter.

Ideal for existing households.You should have an accredited driver because you want to get the full life span of your light at maximum brightness with a good quality driver.It is also important for insurance purposes to have SAA approval for the driver.This driver has SAA approval and EMC.Input is 100-240 volts AC and drives 3 to 6 x 3W LEDs.

Warning: Do not connect the light to the driver while the driver is energised as this will fuse the light and void any warranty.These drivers are current transformers and the secondary output voltage increases dramatically if it is open circuited while there is power to the driver.

Specification Driver

• Input voltage: 100V-240Vac
• Input frequency: 50Hz/60Hz
• Output voltage: 3-34Vdc
• Output power: 3-18W
• Output current: 700mA
• Power factor: <0.99

1. this driver works with all colours of standard and custom Hi power LED light sources
2. electrical characteristics at 25 degrees c ambient temperature
3. protection against short circuit and overload
4. the total value of Vf should be under output voltage;cannot turn on/off on the output side
5. before switching on the supply voltage, all LEDs must be completely wired and connected as per warning above.

Dimensions: 141mmL x 45mmW x 26mmH